Publicidad
Idiomas disponibles
Idiomas disponibles
· Keep the mains cable away from hot surfaces.
· Do not wind the mains cable around the hairdryer.
· Make sure that the mains cable is not twisted or kinked when stored.
· Never use the appliance where aerosol (spray) products are being used or where oxygen is
released.
· To prevent injury, never use the appliance if the heating plates are damaged.
· As additional safety measure, it is recommended that a tested residual current appliance
(RCD) with a residual operating current of not more than 30 mA be installed in the bathroom
circuit. Your electrician will be pleased to help you.
· Dispose of unusable appliance in accordance with the legal provisions of the country in
which the appliance was purchased.
· We are not liable for damage caused as a result of improper use or failure to observe these
operating instructions.
· The appliance is safety insulated and radio screened. It meets the requirements of EU
Directive 2004/108/EC regarding electromagnetic compatibility and EC Low Voltage Directive
2006/95/EC.
CERAMIC and TOURMALINE coating
The coated heating plates have an antistatic effect and are gentle to the hair. Negative ions
close the scale layer, creating a smooth, silky hair surface. and lock in the natural moisture of
the hair, thereby creating the ultimate shine. Negative ions also remove the static charging of
the hair surface.
Operation
· Connect to the mains power supply.
· Using the on/off switch (B), switch on the appliance (Fig. 1a). An acoustic signal will sound
twice. The power light (D) will be illuminated red.
· Set the required operating temperature with the temperature control (C). The temperature
can be set in stages from 150°C – 230°C.
· When the operating temperature has been reached, a tone will sound once and the power
light (D) will flash green.
· After use, switch off the appliance with the on/off switch (B) (Fig. 1b).
· For safety reasons, the appliance switches itself off automatically after 60 minutes. For con-
tinued use, the appliance will need to be switched on again (Fig. 1a).
· Disconnect from the mains power supply.
· Allow the appliance to cool down.
Tips for successful styling
· Wash hair, rinse and dry well.
· Brush or comb hair.
· Section off individual strands of hair.
· At the hairline, place a section of hair between the heating plates.
· Keep the straightener pressed together for a few seconds and slowly pull it down the section
of hair away from the head.
Note: Do not leave the sections of hair in the straightener for more than a few seconds,
otherwise this could damage the hair.
· Open the straightener and allow the section of hair to slip out.
· Repeat the prodedure until the desired result has been achieved.
ENGLISH
de
en
fr
it
es
pt
nl
sv
no
fi
tr
pl
cs
sk
hu
sl
ro
bg
ru
uk
el
ar
9
Publicidad
