Final Installation Checklist; Servicing - GE Zoneline AZ95E Manual Del Propietario Y Instrucciones De Instalación

Installing the Zoneline
11. Install Unit-Mounted Filter
Note: Use only one filter in the installation
• For installs that will use a unit-mounted filter, slide
it down between the provided filter brackets on the
front of the unit, ensuring that any airflow direction
arrows on the filter are pointing toward the unit.
• For installs that will employ a filter withing the return
air grille RAVRG4 or RAVRG2B, do not install
a unit mounted filter. Go to Step 12 and refer to
instructions included in the RAVRG4 or RAVRG2B
return air grille kit for proper filter installation.
12. Install Air Return Grille or
Access Cover
Install the air return grille or access cover per the
instructions that came with the selected kit.
RAVRG4 - Access panel with return air grille
RAVRG2B - Return air grille
13. FINAL INSTALLATION
CHECKLIST
□ Ensure that all installation instructions concerning
clearances around the unit have been adhered to
□ Inspect and ensure that all components and
accessories have been installed properly and that
they have not been damaged during the installation
process.
□ Wall plenum flashing is installed, plenum level and
calked.
□ Unit is level. No tilt allowed.
□ Check to ensure that the unit air filter, indoor coil,
and outdoor coil are free from any obstructions.
□ Check to make sure only one air filter is installed in
the system.
□ Check the condensate water drain(s) to ensure that
they are connected and adequate for the removal
of condensate water and that they meet approval of
the end user.
□ Ductwork is connected and secured to air discharge
outlet.
□ Secure all access panels (e.g. mainboard cover and
junction box cover).
□ Wall thermostat is wired correctly.
□ Unit is wired correctly.
24
13. FINAL INSTALLATION
CHECKLIST (cont)
□ Ensure that the circuit breaker(s) /fuse(s) and
supply circuit wire size have been sized correctly.
□ Ensure the unit has correct line voltage to it, is on a
single circuit and is properly grounded.
□ Ensure that the entire installation is in compliance
with all applicable national and local codes and
ordinances having jurisdiction.
14. Connect Power
1. If all of the items on the final checklist have been
checked and are correct, turn the power ON to the
unit at the main service panel.
2. Turn the thermostat ON and check the unit to make
sure it is functioning as intended.
15. Auxiliary Control Setting, if
required
See the Auxiliary Control Setting section for
instructions on how to program the controls.
Prior to programming the controls, review the final
installation checklist before applying power to the unit.

SERVICING

WARNING
Risk of Electric Shock, can
cause injury or death.
power OFF at the service panel and lock the area to
prevent power from being switched on accidentally.
When the area cannot be locked, securely fasten a
prominent warning device, such as a tag, to the
service panel.
NOTE: We strongly recommend that any servicing be
performed by a qualified individual.
To remove the unit from the closet.
1. Switch the thermostat to OFF.
2. Turn OFF unit at electrical disconnect.
3. Unplug 4 pin connector from unit.
4. Remove cable connector bracket attached to direct
connect kit from unit.
5. Disconnect the wall thermostat wiring from the unit.
Before servicing, switch
49-5000561 Rev. 1