Preparing The Remote Controller; Charging The Batteries - DJI AGRAS T10 Guia De Inicio Rapido

3. Preparing the Remote Controller

Charging the Batteries

Charge the external Intelligent Battery using the charging hub and AC power adapter. Charge the internal battery of the
remote controller using the USB charger and USB-C cable. Fully charge the batteries before using for the first time.
Charging Hub
Mounting the External Battery
Press the battery cover release button on the back of the
1
remote controller down to open the cover.
Insert the Intelligent Battery into the compartment and push
2
it to the top.
Close the cover.
3
To remove the Intelligent Battery, press and hold the
●
battery release button and push the battery downward.
Mounting the 4G Dongle and SIM Card
Only use a DJI-approved dongle. The dongle supports various network standards. Use a SIM card that is
●
compatible with the chosen mobile network provider and select a mobile data plan according to the planned
level of usage.
The dongle and SIM card enable the remote controller to access specific networks and platforms such as the
●
DJI Agras Management Platform. Make sure to insert them correctly. Otherwise, network access will not be
available.
Dongle
* Test procedure: press the remote controller power button and press again and hold to power on the remote controller. In
DJI Agras, tap , and select Network Diagnostics. The dongle and SIM card are functioning properly if the status of all
the devices in the network chain are shown in green.
6
Power Outlet
AC Power Adapter (100 - 240 V)
Remove the dongle compartment cover.
Make sure the SIM card is inserted into the dongle. Insert the dongle into the
USB port and test the dongle.*
Reattach the cover firmly.
USB Charger
USB-C Cable
3
2
Battery Release Button