Skoda 5E5 061 162 Manual Del Usuario página 9

Plastic boot dish
The boot dish is intended for vehicles ŠKODA Octavia (5E).
Order No. 5E5 061 162 - for vehicles ŠKODA Octavia Limousine with
basic floor.
Order No. 5E9 061 162 - for vehicles ŠKODA Octavia Combi with
basic or intermediate floor. In vehicles with intermediate floor push
the boot dish as close as possible to the backseat rests.
Dividing ALU barrier is not included in the set but you can buy it
later from the genuine ŠKODA accessories assortment under Cata-
logue No. 3T0 017 254.
Use and maintenance instructions of the plastic
boot dish
The plastic boot dish serves for protection of the boot against dirt.
Mechanical wear of the plastic boot dish does not deteriorate its
function in any manner whatsoever (i.e. that the warranty does not
apply to any damages caused by usual wear of the dish).
The plastic boot dish is not intended for long-term use. Slight shift
of the booth dish (when loading and unloading transported objects)
might, after some time, cause damage to the neighbour parts (boot
lining). Therefore, if you do not need the boot dish to transport the
objects, we recommend its removal from the boot and storage at a
suitable place.
Clean the plastic boot dish using common cleansing agents for
plastics. In no case use agents containing abrasive solvents.
Push the plastic boot dish into the boot
(Fig. 2, 3 - by the type of the vehicle)
Insert the plastic boot dish into the vehicle boot as shown on rele-
vant figures (Fig. 2 - Octavia Limousine, Fig. 3 - Octavia Combi).
Caution. In vehicles Octavia Limousine insert the boot
dish in inclined position. At the point of the 5th door
sill, the opening into the boot is narrowed. Be careful
not to damage the 5th door seal or the boot lining.
Then push the plastic boot dish slightly onto the boot floor -arrow-.
The position of the plastic boot dish in the boot
(Fig. 4)
Correctly placed plastic boot dish must lie directly on the boot floor.
Placing the dividing barrier in the plastic boot
dish (Fig. 5)
If you need to part the stowage space of the plastic boot dish,
push the dividing barrier in the respective groove in the boot dish
(according to the required size of the space).
If there is no object in the boot dish, insert the dividing ALU barrier
into the so-called stowage position (as close as possible to the
backseat rests) -arrow 1- detail.
Taking the plastic boot dish out of the boot
If you do not intend to use the dish, take it out (for vehicles Octavia
EN
9