Cleaning And Care - Silvercrest SKTG 2200 A1 Instrucciones De Uso

NOTE
The indicator lamp 0 illuminates while the
►
appliance is heating up to the set temperature
level. When the temperature level has been
reached, the indicator lamp 0 goes out.
However, this may come on and go off again
at any time. This indicates that the set tem-
perature has briefl y fallen and the appliance
is heating itself back up.
2) Apply a little vegetable oil to the griddles
2/3/4.
NOTE
► Excess fat or other fl uids will run into the fat
drip tray 6!
3) Place the food to be grilled on the appropriate
griddles 3/4:
–
Food that needs to be cooked on both sides
at the same time should be placed on the
lower griddle of the contact grill 3; then
close the lid so that the upper griddle of the
contact grill 2 is on top of the food.
NOTE
► The hinges of the lid are designed especially
so that the lid adapts to the thickness of the
food to be grilled and lies fl at on top of the
food.
If the lid does not lie fl at on top of the food,
the food is too thick for the contact grill. In
this case, use the teppanyaki griddle 4.
–
Lay food that is too thick to be cooked
evenly in the contact grill on the teppanyaki
griddle 4 and turn it at regular intervals.
4) Remove the food from the griddles 3/4 with
the help of heat-resistant plastic or wooden
implements once it is ready.
5) Turn the thermostat 9 to "0".
6) Remove the plug from the mains power socket.
SKTG 2200 A1

Cleaning and care

DANGER – RISK OF ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect
the plug from the mains power socket! Risk of
electric shock!
NEVER immerse the appliance in water or
other liquids!
WARNING! RISK OF INJURY!
► Always allow the appliance to cool down
before cleaning it. Otherwise there is a risk
of burns!
ATTENTION! DAMAGE TO PROPERTY!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surface of
the appliance!
Use the plastic spatula q to push any excess
■
fat or liquid through the outlet 7 into the fat
drip tray 6. Wipe up any remaining fat using
a kitchen towel.
Wipe the griddles 2/3/4 with a moist cloth.
■
NOTE
► If any stubborn residue is still stuck to the
griddles 2/3/4, add a little detergent
to the damp cloth. After this, wipe off the
griddles 2/3/4 with clean water. Ensure
that no detergent residue remains on the
griddles 2/3/4.
► If you have used detergent to clean the
griddles 2/3/4, make sure that you rub
them lightly with oil again afterwards, other-
wise the non-stick coating will not function
optimally.
GB
MT
37