Safety Warnings Specific For Polishing Operations; Additional Safety Instructions; Noise And Vibration; Operating Instructions - Flex PE 14-2 150 Instrucciones De Funcionamiento Originales

PE 14-2 150, PE 14-1 180
Safety Warnings Specific for
Polishing Operations:
Do not allow any loose portion of the

polishing bonnet or its attachment strings to
spin freely. Tuck away or trim any loose
attachment strings. Loose and spinning
attachment strings can entangle your
fingers or snag on the workpiece.

Additional safety instructions

The mains voltage and the voltage

specifications on the rating plate must
correspond.
Do not press the spindle lock until the tool

stops.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power
tool is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value (when polishing
painted surfaces):
– Emission value a
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The declared vibration emission
level represents the main applications of the
tool. However if the tool is used for different
applica-tions, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
For a precise estimation of the vibration load
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use.
: 80 dB(A);
pA
: 91 dB(A);
WA
K = 3 dB.
: <2.5 m/s
h
K = 1.5 m/s
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).

Operating instructions

WARNING!
Before carrying out any work on the
polisher, always pull out the mains plug.
CAUTION!
The available mains voltage and the voltage
specifications on the rating plate must
be the same.
Before switching on the power tool
Unpack the polisher and check that there

are no missing or damaged parts.
Attaching the auxiliary handle
The auxiliary handle can be attached
2
to improve handling of the polisher.
2
To do this, remove the handle cover
fastening screw from the side on which the
handle is to be attached.
When removing the handle, put back
the screw which was removed beforehand.
15