PE 14-2 150, PE 14-1 180
Switch on the polisher (without engaging
it) and run the polisher for approx.
30 seconds. Check for imbalances and
vibrations.
Switch off the polisher.
Changing the tool holder
Pull out the mains plug.
Press and hold down the spindle lock.
Unscrew tool holder anti-clockwise and
screw it off the spindle.
Attach new tool holder (see above).
Attaching the tools
CAUTION!
Attach the tools in the centre of the tool
holder. Imbalances may damage the power
tool. The work result may be impaired.
Operating instructions
NOTE
When the power tool is switched off, the tool
continues running briefly.
If using a polishing paste, use the respective
tool for each paste.
On sensitive surfaces (e.g. car paintwork)
do not work aggressively but work at slow
speeds applying low contact pressure.
Sponges can be washed in the washing
machine.
For further information on the manufactu-
rer's products go to www.flex-tools.com.
Maintenance and care
WARNING!
Before carrying out any work on the
polisher, always pull out the mains plug.
Cleaning
WARNING!
If metals are work over a prolonged period,
conductive dust may become deposited
inside the housing. Impairment of the
protec-tive insulation! Operate the power
tool via a residual-current-operated circuit-
breaker (tripping current 30 mA).
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The polisher features cut-off carbon
brushes.
When the wear limit of the cut-off carbon
brushes is reached, the polisher switches
off automatically.
NOTE
Use only original parts supplied by the
manu-facturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the power tool is being used, the
carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes spark excessively,
switch off the polisher immediately.
Take the polisher to a customer service
workshop authorised by the manufacturer.
Gears
NOTE
Do not completely remove the handle cover
during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
17