Mounting; Electrical Installation - SICK WTB16 Instrucciones De Operación

4

Mounting

5

Electrical installation

8022691.10DR | SICK
Subject to change without notice
Center of optical axis, receiver
3
Fixing hole, Ø4.1 mm
4
Connection
5
LED indicator green: Supply voltage
6
active
LED indicator yellow: Status of
7
received light beam
Press-turn element: Adjusting the
8
sensing range
BluePilot blue: Sensing range dis‐
9
play
Mount the sensor using a suitable mounting bracket (see the SICK range of acces‐
sories).
Note the sensor's maximum permissible tightening torque of < 1,3 Nm.
Vorzugsrichtung des Objektes zum Sensor beachten,
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: Note pin assignment.
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanations of the connection diagram
MF (pin 2 configuration) = external input, teach-in, switching signal
Q /C = switching output, IO-Link communication
L1
see figure 1,
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
(table 1, table 2).
4
MOUNTING
figure 2.
5