AEG UltraMix KM4 Serie Manual De Instrucciones página 8

• If the appliance or the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified person, in order to
avoid hazard.
• Always place the appliance on a flat, level surface.
• Always disconnect the appliance from the supply if it is left unattended and
before assembling, disassembling or cleaning.
• Appliance is for indoor use only.
• Do not immerse the appliance, cord or plug in water or any other liquid.
• Do not let cord hang over edge of table or counter, do not let cord contact
hot surface, including the stove.
• Never use accessories or parts made by other manufactures not
recommended or sold; may cause a risk of injury to persons.
• Make sure the motor has completely stopped before disassembling and
cleaning.
• Avoid contact with moving parts. Contact could result in injury! Do not use
other tools or utensils during the appliance usage.
• Do not leave this product out of your sight when it is running.
• Ensure all loose matters and your clothes/accessories are kept away while
using this product.
• Never process boiling liquids (max 90°C).
• Do not use this appliance to stir paint. Danger, could result in an explosion!
• Never operate appliance with the attachments wire whip, flat beater or
dough hook unless the bowl is in place.
• This appliance is intended for domestic use only. The manufacturer cannot
accept any liability for possible damage caused by improper or incorrect
use.
TROUBLESHOOTING
PROBLEM
The motor slows down
during operation.
The motor does not work.
The appliance vibrates/
moves during operation.
The attachment scrapes
the Stainless steel bowl
during operation.
www.aeg.com
KM4xxx_StandMixer_AEG NO-FARSI.indd 8
POSSIBLE CAUSE
Amount of dough may exceed maximum
capacity.
Dough may be too wet, it sticks onto the side
of the bowl..
The appliance is not connected to the mains.
The rubber feet are wet.
It is normal for heavy loads (e.g heavy dough,
cheese).
The height of the attachment shaft is incorrect.
SOLUTION
Remove half and process in two batches.
Add more flour, 1 tablespoon at a time
until the motor speeds up. Process until
dough cleans the side of the bowl.
Make sure to plug in the appliance
before operation.
Make sure the rubber feet at the bottom
of the unit are clean and dry.
Remove half and process in two batches.
Adjust the height of the attachment
shaft.
2017-07-06 13:02:06
8