Triton T12RS Instrucciones De Uso Y De Seguridad página 11

Troubleshooting
Problem
Red LED does not illuminate and Battery
(9) not charging
Battery has low capacity
Saw cannot be switched on (Trigger (6) does
not move)
Saw does not start when Trigger is pressed
Poor cutting action
When cutting an unsecured workpiece, the
workpiece is vibrating and moving with the cut
GB
10
539277_Z1MANPRO1-USA.indd 10
Possible cause
Battery not fully seated
Battery Charger (13) not powered
Battery not being fully charged
Battery has been charged over 100 times and
capacity has started to reduce
Trigger Lock (5) is engaged
Battery completely discharged
Defective Battery
Saw defective
Worn or incorrect blade
Material may be beyond the capabilities of the
saw with the fitted blade despite the blade
matching the material
There is a gap between the Shoe (1) and the
workpiece
The blade is bi-directional
The blade tooth pitch is too coarse
Solution
Refit battery correctly
Recheck mains connection
Wait until Green LED is illuminated
This is normal for batteries. Contact your Triton
dealer to purchase a replacement battery
Move Trigger Lock to the unlocked position
Recharge Battery or replace with a fully charged
battery
Replace Battery
Contact your Triton dealer or authorised service
centre
Replace blade
Replace blade with a finer tooth pitch blade to
reduce the load on the saw motor
Ensure there is no gap, see Fig. D
Use a uni-directional blade so it mainly cuts as it
pushes the material towards the Shoe (1)
Use a finer tooth pitch so less material is cut per
reciprocating action and smoother cutting
26/09/2014 11:20