Innotek KIT11122 Instructivo página 3

1
PREPARATION
Adjusting the collar
to the spray device
1. Remove the keeper
from the black collar
(1). Pass the black
collar through the
loops (2) of the spray
device (3) while
making sure that the collar does not block
the microphone's opening (4). Put the keeper
back on the collar (5). The curved edge of the
keeper should face inside.
2. Feed the free end of the collar into the fi rst
slot of the buckle from the back to the front
(6). Then, thread the free end of the collar through the outside slot from
the front to the back (7). The free end should now hang on the outside,
then thread the keeper (8). When you have completed this section, the
assembled collar looks as illustrated (9).
Take off all other collars your dog may be wearing and place the Spray
Collar around his neck, making sure the spray valve is directed toward the
snout. Adjust the collar to fi t like a regular collar. You should be able to
easily pass two fi ngers (10) between your dog's neck and the device. We suggest that you check
the collar regularly to make sure that it is well adjusted.
Note: If these instructions are not properly followed, the buckle can easily be pulled off the collar.
This could lead to the device being lost or damaged. Your dog must get used to the device before
you actually start using it. We suggest that you make your dog wear the Anti-Bark Spray Collar™
during 4 to 5 days before inserting the battery and fi lling the device. At the same time, we also
suggest that you remove and put the collar back frequently on your dog.
2
5
www.innotek.com
3
6
8
4
7
9
10
3