Filling The Device; Inserting The Battery; Do'S And Don'TS - Innotek KIT11122 Instructivo

FILLING THE DEVICE

1. Set the device on a fl at surface, with the fi ll-up
valve turned upwards (11). Shake the spray can
before using it.
2. Hold the can upside down, then insert the
aerosol tip in the fi ll-up valve – the deepest
cavity (12) – then press down fi rmly for 10
seconds (13). Release pressure and press down
for another 10 seconds, then release. Note: If
spray is escaping as you attempt to fi ll the device,
increase the downward pressure on the refi ll can to
get a better seal. You cannot overfi ll the device.
When completely fi lled, there should be enough
gas in your device for 18-23 sprays.

INSERTING THE BATTERY

Slide off the battery cover (14) and insert the 6-volt
alkaline battery without forcing it (15), keeping the
polarity in mind (+ and -). Slide the cover back on
(16).
Turn the device on - Before every use, it is best to
test the device by blowing into the microphone.
Adjust the Spray Collar onto the dog's neck with the microphone's opening facing inwards.
Direct the spray valve towards the dog's snout.
Your Anti-Bark Spray Collar™ will now react when your dog barks. Training, in addition
to using the device, will accelerate and consolidate the desired behavior (behaviour)
modifi cation.

DO'S AND DON'TS

• The collar should be worn only during periods of nuisance barking and no more than eight
hours per day.
• The collar must be fi lled to maximum capacity before placing it around your dog's neck.
• Never fi ll the device while your dog is wearing it because it may damage the fi ll-up valve.
• To ensure that your dog does not make the connection between you and the spray collar, don't
let him see you prepare the device, neither for the fi rst try, nor for subsequent use. Keep your
dog away while you prepare the device as well as when you fi ll it or change the battery.
• It is important that your dog's hair doesn't block the spray valve. Try tying a bandanna
(handkerchief ) around your dog's neck, then place the spray collar over it. If necessary, you may
also consider trimming a little of the long hair around the dog's neck for better spray eff ect.
• Remove all other collars with metallic parts or tags. These could create noise that may needlessly
activate the spraying device.
4
11
13
15
www.innotek.com
12
14
16