Pin Assignment Of The Connections; Connecting The Supply Voltage - SICK PowerProx Micro WTT2SL Instrucciones De Operación

Ocultar thumbs Ver también para PowerProx Micro WTT2SL:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 102
5.2

Pin assignment of the connections

5.3

Connecting the supply voltage

8021879.ZZG2 | SICK
Subject to change without notice
NOTE
Layout of data cables
Use shielded data cables with twisted-pair wires.
Implement the shielding design correctly and completely.
To avoid interference, e.g., from switching power supplies, motors, clocked drives,
and contactors, always use cables and layouts that are suitable for EMC.
Do not lay cables over long distances in parallel with voltage supply cables and
motor cables in cable channels.
The IP enclosure rating for the device is only achieved under the following conditions:
The cables plugged into the connections are screwed tight.
Any electrical connections that are not being used must be fitted with protective
caps that are screwed tight (as in the delivery condition).
Any other lids present must be closed and lie flush on the device.
If these instructions are not complied with, the IP enclosure rating for the device is not
guaranteed!
Overview of pin assignment
Table 1: M12-Stecker, 4-polig
-2X329x
1
+(L+)
2
Q
3
-(M)
4
Q
4
3
1
2
NOTICE
Risk of damage to the device!
The device can become damaged if it is connected to a voltage supply that is already
switched on.
Only connect the device when the supply cable is de-energized.
The device must be connected to a power supply unit with the following properties:
Supply voltage DC 10.8 V – 28.8 V (SELV/PELV as per currently valid standards)
Electricity source with at least 3 W power
To ensure protection against short-circuits/overload in the customer's supply cables,
the wire cross-sections used must be appropriately selected and protected.
ELECTRICAL INSTALLATION
-2X119x
+(L+)
Q
-(M)
Q
1 = BN
4
2 = WH
3 = BU
4 = BK
1
0.09 mm
2
AWG 28
5
C-2Xxx9xAxx
+(L+)
MF
-(M)
Q
/C
1
1 = BN
3
2 = WH
3 = BU
4 = BK
2
0.09 mm
2
AWG 28
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Powerprox micro wtt2slcPowerprox microWtt2slWtt2slc

Tabla de contenido