Safety Information; General Safety Notes; Intended Use; Improper Use - SICK PowerProx Micro WTT2SL Instrucciones De Operación

2

Safety information

2.1

General safety notes

2.1.1 Safety notes
2.2

Intended use

2.3

Improper use

8021879.ZZG2 | SICK
Subject to change without notice
Read the operating instructions before commissioning.
■
■
- Connection, mounting, and setting is only to be performed by skilled per‐
son.
■
NO
2006/42/EG
- Not a safety component in accordance with the EU Machinery Directive.
SAFETY
■
- Do not install the sensor at locations that are exposed to direct sunlight or
other weather influences, unless this is expressly permitted in the operating
instructions.
When commissioning, protect the device from moisture and contamination
■
These operating instructions contain information required during the life cycle of
■
the sensor.
LASER CLASS 1
Laser
1
EN/IEC 60825-1:2014
IEC60825-1:2007
Maximum pulse power < 20 mW
Puls length: 5.3 µs
Wavelength: 940 nm
Complies with 21 CFR 1040.10
and 1040.11 except for deviations
pursuant to Laser Notice No. 50,
dated June 24, 2007
ATTENTION
WARNING: Interruption, manipulation or incorrect use can lead to hazardous exposure
due to laser radiation.
The WTT2SL(C) is an opto-electronic photoelectric proximity sensor (referred to as "sen‐
sor" in the following) for the optical, non-contact detection of objects.
The system designer must provide measures to ensure the safety of persons and sys‐
tems in accordance with the legal guidelines.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
• The device does not constitute a safety-relevant device according to the EC
Machinery Directive (2006/42/EC).
•
The device must not be used in explosion-hazardous areas.
SAFETY INFORMATION
2
7