Pahlen Spotlight LED 60 Classic Manual Del Usuario página 13

Spotlight LED 60 Classic
Install cable for LED as follows:
Connector installation
1
Connector installation
1
1. Loosen screws in socket (B) so that the hole for cable 2
3
opens leaving space enough for actions with cable guides.
3
4
page 6 of 20
3. Make sure the cable cover goes right under the socket.
page 6 of 20
If the cable is not dragged sufficiently far, there is a risk that the
silicone seal will not function properly. Water may then leak into
the lamp.
5
5. Cut or cut off the piece of the guide that sticks
through the socket
For the pool framework made of wood, metal or plastic - finished with liner
Plug
Sealing sleeve
Cable transmission
A LED-module
B Connector/Socket
C Silicone packing
D Nut
E Cable, 4m
Connector installation
2
1
2
3
4
page 6 of 20
5
6
page 7 of 20
Pool frame
plywood/sheet
O-ring
Injection pipe with flange
O-ring
Mounting ring
Countersunk screw M5x30 (4 pcs)
A B
2
2. Pull seal (C) onto the cable (E)
Pull cable guide through the socket.
4
4. Tighten screws.
5
Make sure the screws are firmly seated.
6
6. Align the socket into the LED module (A).
Make sure the seal is properly sealed.
Tighten nut (D).
Wall mat
Self-adhesive packing t=1,5 mm
13
ENGLISH
C D
6
page 7 of 20
Liner
LED-module with cable
Countersunk
screw M5x20
(2 pcs)
Front
Countersunk screw
M5x16 (6 pcs)
Sealing ring
Packing t=2 mm
E
page 7 of 20