Cleaning - Skymsen SFL-282HD Manual De Instrucciones

the Blade cu ng the product at constant speed.
A er finishing the whole slice remove it with the right hand.
The slice shall ALWAYS be removed behind the Blade to
avoid the hand to contact the Blade
Place the slices upon the Fixed Table # 05 (Pic. 01).
Bring back the Movable Table to the front side of the
machine and repeat the above steps un l to have finished
to cut all the product.
A er the end of the last slice turn the ON/OFF Switch to the
posi on "O" (OFF) # 13 (Pic 01).

5. CLEANING

When the equipment must go through a complete cleaning
and sani za on process:
- Before to be used first me.
- A er every day end of opera ons
- When the saw is not going to be used for a long period.
- Before to start opera on a er a long period it has not been
used.
Some components may be removed to clean:
- Door
- Fixed Table Block
- Blade
- Thickness Guide
- Blade Scraper
Follow below instruc ons to remove the above men oned
components:
Doors
Turn the two Doors handle counterclockwise un l they get
free from their screws. Open the Door #01 (Pic. 03), hold it
firmly and li it.
Picture 03
01
01
Fixed Table Block
Remove the Fixed Table Block #01 (Pic. 04) just li ing it , see
picture 04. Picture 04
Blade
Turn the Blade Tension Regulator Handle # 01 (Pic 05)
counter clockwise to get the Blade # 02 (Pic. 05) free to be
removed.
Picture 05
02
Thickness Guide
Turn the handle # 01 (Pic.06) counterclockwise and slide the
sha to the le un l it loose from the base. Li up the Cut
Regulator and remove it.
Picture 06
01
Blade Scraper
Once the blade is removed, Blade Scraper #01 (Pic.06) is
free to remove.
Picture 07
01
Use a clean cloth or a so brush to remove residues.
Wash, sani ze, rinse and dry all the components.
Assemble back all the components following the inverse
01
path, and make sure all the components are correctly in
place.
Pase el lector de QR Code para obtener
informaciones sobre cuidados con los
aceros inoxidables.
SFL-315HD 110 V 60 Hz
01