Initial Calibration; Menu Structure - OHAUS Navigator NV222 Guia De Inicio Rapido

Quick Start Guide

4. INITIAL CALIBRATION

This quick start guide explains how to use the basic functions of the instrument. For
information about advanced features, refer to the instruction manual.
When the balance is first installed it should be calibrated to ensure accurate results.
Press and hold Menu until [mMeNU] (Menu) is displayed. When the button is released,
the display will display [.C.A.L.]. Press "Yes" to accept, [SpaN] will then be shown. Press
"Yes" again to begin the span calibration.
[--C--] blinks while zero reading is stored. Next, the display shows the calibration
weight value. Place the specified calibration mass on the pan. [--C--] blinks while the
reading is stored. The balance returns to the previous application mode and is ready for
use.
5. OPERATION
5.1. Controls
Button
Zero
Yes
Print
Units
No
Function
Mode
Back
Tare
Menu-Cal
Exit

5.2. Menu Structure

Sub-Menus:
Menu Items:
* Note: Available settings vary by models and regions.
Ohaus Corporation
Functions
Short Press (when on): Sets display to zero
(when off): Turns balance on
Long Press (when on): Turns the balance off
Short Press (in Menu): Selects/accepts displayed setting
Short Press: See Interface Manual for operation description.
Long Press: Toggles through active units
Short Press (in Menu): Toggles through available settings
Short Press: Selects function setting
Long Press: Selects active Mode
Short Press (in Menu): returns to previous settings
Short Press: Enter / clear a Tare value
Long Press: Enters User Menu
Short Press (in Menu): Quickly exit User Menu
.C.a.l. .S.e.t.u.p.*
Span A-off
Lin Disply
Bright
IR
End End
www.ohaus.com
.M.o.d.e. .U.n.i.t.*
Count ct, g, kg,
Percnt grn, lb, oz,
Check lb:oz, ozt,
N, dwt,
thk, tsg, ttw,
End tola, tical
End
3
TM
Navigator
.E.n.d.
TM
Navigator