Connecting The Interface; Leveling The Equipment; Initial Calibration - OHAUS Adventurer Manual Instrucciones

EN-2

2.3 Connecting the Interface

Use the built-in RS-232 Port to connect either to a computer or a printer with a standard (straight-through) serial cable.
Or connect using the scale's USB port.
Interface connections on the rear of the balance:
.
USB1
USB1: Used to connect to PC only
USB2: Used to connect a USB flash driver only
RS232: Used to connect to PC or Printer

2.4 Leveling the Equipment

To level the instrument, adjust the feet/leveling wheel so the bubble is centered in the circle of the level indicator. Be sure the
equipment is level each time its location is changed.

2.5 Initial Calibration

For best results, the instrument's calibration should be checked prior to first use. If adjustment is needed, refer to the
Calibration section of the instruction manual.
RS232
USB connection on the front of the balance: