HAMPTON BAY 91252 Guía De Uso Y Mantenimiento página 13

Assembly - Installing the Light Kit (continued)
2
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock,
disconnect the electrical supply circuit to the fan before
installing the light kit.
□
Remove one screw (RR) from the black bracket below fan
motor assembly (E). Loosen but do not remove three of
four mounting screws.
□
Connect the blue wire exiting the bottom of the fan motor
assembly (E) with the black wire from the light kit fitter
assembly (F).
□
Connect the white wire exiting the bottom of the fan motor
assembly (E) with the white wire from the light kit fitter
assembly (F).
□
Push the light kit fitter assembly (F) up to the fan motor
assembly (E) so that the three loosened screw heads fit into
the keyhole slots. Turn the light kit fitter assembly (F) to
secure.
□
Re-install the screw that was removed in step 1.
3
Installing the glass bowl and light
bulbs
WARNING: Do not overtighten when installing the glass
shade into the light kit assembly. Allow the glass shade to
cool completely before removing.
□
With the power off, install the two LED bulbs (M) (9.5 Watt,
max) by screwing them into the light bulb sockets.
□
Remove the finial (WW), hex nut (SS) and rubber washer
(XX) from the threaded nipples of the light kit fitter
assembly (F).
□
Position the glass bowl (I) into the light kit pan (H) over the
threaded nipple.
□
Re-install the rubber washer (XX) and the hex nut (SS) to
the threaded nipple, hand tighten the hut (SS) to secure.
□
Re-install the finial (WW) to the threaded to secure the
glass bowl (I) properly.
H
F
RR
SS
13
Please contact 1-855-HD-HAMPTON for further assistance.
F
M
I
XX
WW
HAMPTONBAY.COM