HAMPTON BAY 91252 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (EE) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (FF) located in the "L shaped"
slots.
□
Remove and save the two canopy screws (GG) in the round
holes. This will enable you to remove the mounting bracket (A).
FF
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly falling.
NOTE: This fan is equipped with a safety tab (EE). Should
the setscrew (DD) ever become loose while the fan is
running in reverse, the safety tab (EE) will engage and
stop the fan from falling.
□
Loosen, but do not remove, the setscrews (HH) on the collar on top
of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in the collar
and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews (HH) on the collar on top of the fan-motor
assembly (E).
2
Routing the wires
□
□
□
A
GG
C
EE
B
D
CC
7
Route the wires exiting the top of the fan motor
assembly (E) through the center of the canopy ring (EE).
Make sure the slots on the canopy ring (EE) are on top.
Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (D) onto the end
of the ball/ downrod (B). Make sure the slots on the
canopy (C) are on top.
Route the wires exiting the top of the fan motor
assembly (E) through the downrod (B) as shown.
HH
Please contact 1-855-HD-HAMPTON for further assistance.
C
EE
B
D
E
C
DD
MM
E
HAMPTONBAY.COM