Bench Alignment - Össur CHEETAH Instrucciones De Uso

ENGLISH
cHEETaH SYSTEM
• Custom foot for track & field sports
• Preferred transtibial sprinting foot
• Clearance for hardware
Minimum: 250mm (10") for Pylon Adapter (D)
Maximum: 32mm (1 1/4") for lamination adapter (C)
• Maximum weight 147 kg (325lbs) for lamination adapter
• One adult foot size
cONNEcTOR OPTIONS (a)
Pylon Connector FSX50003 (1-6), FSX50004 (7-9)
• Used for clearance greater than 250mm (10")
• Adapter is laminated direct to the back of the
socket protruding from the apex of the distal
socket to allow attachment of the foot.
Bolts go through adapter first then through foot module. Apply Loctite
410 to all threads and torque to following specifications:
category
M 1-6
L 7-9
LaMINaTION cONNEcTOR (b)
FSX50001 (1-6), FSX50002 (7-9)
• Used for clearance less than 250mm (10")
• Adapter is laminated direct to the back of the socket
Bolts go through adapter first then through foot module. Apply Loctite
410 to all threads and torque to following specifications:
category
M 1-6
L 7-9
THE cHEETaH™ MaY aLSO bE cONNEcTEd bY a dIREcT
LaMINaTION.
FRIcTION PadS
Always use between T and foot module. If alignment wedges are used,
place friction pads between each layer.

bENcH aLIGNMENT

Sagital plane (c+d)
• Load line bisects socket and falls through the ground contact point or
approximately 5cm (2") posterior.
• Determine the appropriate socket flexion according to amputee
requirements.
coronal plane
• Introduce appropriate socket abduction/adduction (using a jig)
• 5°-7° additional external rotation
• Achieve proper height approximately 25mm (1") longer than the
bolt Size
5/16"
3/8"
bolt Size
5/16"
3/8"
Torque
33 Nm (24 ft-lbs)
45 Nm (33 ft-lbs)
Torque
33 Nm ( 24 ft-lbs )
45 Nm ( 33 ft-lbs )
4