Replace The Batteries - Kohler K-10958 Guía De Mantenimiento

Batteries

Replace the Batteries

CAUTION: Risk of property damage. Do not over tighten
the screws as plastic threads can be readily damaged.
NOTE: Replacement batteries can be purchased from most
convenience stores. The batteries are 1.5 volt "AA" alkaline batteries.
This unit requires four batteries.
NOTE: If replacing the sensor, adapt this procedure to install a
battery in the new sensor unit before installing the sensor.
It is not necessary to remove the sensor from the cap to replace
the batteries.
Use a 3/32" hex head wrench to remove the two screws from the
bottom of the DC sensor.
Remove the battery holder assembly.
If necessary, use a small flat bladed screwdriver to pry the
batteries from the battery holder.
NOTE: The batteries may be considered hazardous waste. Discard
the old batteries in accordance with any applicable codes.
Remove and discard the old batteries.
Align the new batteries so that the metal pole on the battery will
contact the metal electrodes in the battery holder. Take care to
install each battery in the proper orientation, as shown on the
battery holder.
Kohler Co.
DC Sensor
Battery Holder
Screws
9 1061436-5-B