How To Wire Your Ceiling Fan - Fanimation PICKETT FP7996 Serie Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

NOTE: If fan or supply wires are different colors than indicated, ha

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before

(Figure 1).

NOTE: If you are not sure if the outlet box is

grounded, contact a licensed electrician for advice, as

it must be grounded for safe operation.

1. Disconnect the power and remove the existing

wall plate and switch.

2. Set the knob and light switch of the wall-mounted

control in the off (0) position.

3. Make wire connections and secure with wire nuts

supplied. (Figure 2)

Connect the Black wire (AC IN L) from the

wall-mounted control with the wire from the AC

power supply.

Connect the Black wire (To Motor L) from the

wall-mounted control with the Black wire from the

ceiling fan.

Connect the White wire from the ceiling fan to

the AC power supply.

Connect the Blue wire (To Light) from the

wall-mounted control with the Blue wire from the

ceiling fan.

Connect the green/yellow wire from the

wall-mounted control with ceiling fan and ground

wire from the AC power supply.

4. Carefully push all connected wires inside wall

switch box.

Check to see that all connections are tight,

including ground, and that no bare wire is visible at

the wire connectors, except for the ground wire. Do

not operate fan unless blades are in place. Noise

and fan damage could result.

5 .

Secure the wall-mounted control to the outlet box

with two screws provided. Then attach the face plate

to the wall control with the two painted screws.

(Figure 3)