Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: This step is applicable after the neccessary wiring is completed.
1.
Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the keyslot twist-lock feature. (Figure 2)
How to Assemble Your Ceiling Fan Blades
1.
Slide blades through slots in motor housing and
attach to the motor hub using the 3/16˝-24 serrated
head screws and flat washers. Make sure the screws
securing the blades to the motor hub are tight and
are properly seated. (Figure 1)
NOTE:
Periodically check blade hardware and
resecure if necessary.
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
How to Install Your Canopy Housing
WARNING
CAUTION
HARDWARE USED:
SERRATED HEAD
SCREWS
FLAT WASHER
10
Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Motor
Blade
3/16˝-24 Serrated Head Screw
with Flat Washer (3 per blade)
Figure 1
x 12
x 12
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
