How To Assemble Your Light Kit - Fanimation PICKETT FP7996 Serie Manual De Instrucciones

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later. Slightly loosen the
remaining two screws. (Figure 1)
2. Assemble the switch housing assembly to the support
bracket using the two key slots in the switch housing
assembly. Replace the third screw and securely tighten
all three screws. (Figure 2)
3. Remove one of the three screws in the switch
housing assembly and retain the screw for Step 5.
Slightly loosen the remaining two screws. (Figure 3)
4. Connect the 2 pin connectors from the LED
assembly to the 2 pin connectors from motor
assembly. (Figure 4)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
5. Assemble the LED assembly to the switch housing
assembly using the screw removed in Step 3 and
securely tighten all three screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
6. Assemble the glass to the LED assembly by
twisting in a clockwise direction. Do not overtighten.
(Figure 6)

How to Assemble Your Light Kit

Switch Housing
Assembly
LED Assembly
11
Figure 1
Motor
Switch Housing
Assembly
Figure 2
Switch Housing
Assembly
Figure 3
Motor
LED Assembly
Figure 4
LED Assembly
Figure 5
Glass
Figure 6