Manual Set-Up - DiO VDP-IP01 Guía Rápida

6.1 Set-up via QR code
Select the settings menu from the home screen on your videophone monitor
Then select the configuration icon
Go to "Guarding Vision service parameters" to record the unit's QR code.
In the "Guarding Vision" app on your smartphone, select the "+" icon in the top right corner.
Select "Analyse code" from the drop-down menu.
Use your camera to scan the QR code on the videophone screen.

6.2 Manual set-up

Select the settings menu from the home screen on your videophone monitor
Then select the configuration icon
Go to "Information on the device" to record the serial number of the device.
In the "Guarding Vision" app on your smartphone, select the "+" icon in the top right corner.
Select "Add manually" from the drop-down menu.
Enter the serial number shown on the screen of your videophone.
Note:
The default password for your device is 123456
The default verification code for your device is ABCDEF
7. Special features of the videophone
7.1 Language change
To change the language of the 2 units, follow these steps:
1. Go to the «Configuration» settings on the display.
2. Enter your password
3. Select the language
4. The screen will restart the system
5. Return to the «Configuration» settings to confirm your choice of language.
6. Follow the steps (See point 4 «initial configuration»).
7. Wait until the 2 units are connected.
In the upper right corner, you will see:
No device connected
Connection between the 2 units
SIP = Session Initiation Protocol: is a standard protocol for establishing a session between two or more sessions. In this case, the
connection between the 2 units.
7.2 In case of absence
With the «automatic answer» option, the videophone informs the visitor that it is busy, and gives him the possibility to leave a
voice message.