Uw Models With P-Computer; Start-Up; Opening Door; Loading - Alliance Laundry Systems UW100VV Suplemento De Instalacion/Operacion

Installation/Operation Supplement

UW Models with P-Computer

Start-Up

Turn on the main power source (circuit breaker or
cut-off switch on the wall).

Opening Door

Use left hand to press and hold the Door Unlock
button located on the lower right front of the control
panel. Refer to Figure 7.
Figure 7
Use right hand to turn door handle clockwise and
swing the door left to open. Refer to Figure 8.
Figure 8
24
MD003J
MD004J
MD004J
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Loading

Load the washer-extractor to full capacity whenever
possible. DO NOT OVERLOAD.
NOTE: When washing items which may
disintegrate or fragment such as mop heads or
sponges, use laundry nets to prevent drain
blockage.

Supply Dispenser

Place dry supplies in the supply dispenser
compartment cups prior to the start of each cycle.
Liquid supplies can be injected directly into the supply
dispenser by an external chemical supply system.
NOTE: Supply dispenser compartment cups must
not be removed when an external chemical
injection supply system is attached to the washer-
extractor.

Cycle Selection

NOTE: Press keys at their centers just hard enough
to activate them.
Find the cycle number of the desired wash cycle.
Cycle numbers must be two-digit numbers from 01 to
39. Press the Start key to start the cycle.
Press the numbers desired on the keyboard and note
that these numbers are displayed after "NEXT".
When keys are pressed on the keyboard, a beep will be
heard. If an error is made, press the numbers again. As
numbers are entered, they move from right to left on
the display. Cycle is complete when display reads
"donE".
F232156