Indication For Use - Össur REBOUND DIABETIC WALKER Instrucciones De Uso

ENGLISH

INDICATION FOR USE

Promotes healing of plantar ulcers by offloading and by protection and
immobilization of the foot.
CAUTIONS/WARNINGS
• This Product Contains Natural Rubber Latex Which May Cause
Allergic Reactions.
• Read the following instructions carefully before using the device.
• Rx Only.
• Modifications to this product are to be made only by a physician's
order.
• Weight limit: User's maximum weight is 136 kg (300 lbs).
• Hexplugs should only be removed or altered by a healthcare provider
as instructed by a physician.
• Wounds under treatment should be monitored closely for
maintenance of pressure relief and healing progress.
• In case of emergency the compliance strap can be cut with scissors
for removal of the walker.
• The insole should not be used in conjunction with any other walker or
footwear.
• Before reapplying the device inspect:
– The foot for any rash, sores, new ulcers or other indications of
skin irritation.
– The boot, bladders and liners for any damage.
• User should be cautious when walking on slippery or wet surfaces to
avoid injury.
• If skin irritation of any kind develops or any problems occur with the
use of this product, immediately contact your healthcare provider.
• Do not remove the walker unless instructed by a physician or for
emergencies.
• If the walker has become loose or uncomfortable to wear, readjust the
straps as necessary and contact your healthcare provider if discomfort
is not relieved.
• This product has been designed and tested for single patient usage
and is not recommended for multiple patient usage.
• This product is not intended for use on patients with chronic Charcot
feet with a rocker bottom deformity.
• This product is only intended for use in treating plantar ulcers of the
foot.
INSTRUCTIONS FOR FITTING
1. Unfasten the straps, remove the front shell and open the liner.
2. Cover the wound with an appropriate dressing.
3. To heat mold the insole:
– Apply the supplied sock over the patient's foot/dressing, prior to
placing foot on heated insole.
– Do not remove hexplugs prior to heat molding.
– Pre-heat the oven to 110°C (230°F).
– Heat the insole for three minutes at 110°C (230°F).
– Have the patient stand, wearing the sock, on the pre-heated insole
for one minute (Figure 1).
– Have the patient remove foot from the insole.
5