Publicidad
Idiomas disponibles
Idiomas disponibles
3. Next, select the Passenger side Front Support Bracket, (Figure 3). IMPORTANT: Use the
illustration above to help identify the correct Support Bracket. Use (1) 10mm Hex Bolt, (2)
10mm Flat Washers and (1) 10mm Nylon Lock Nut to attach the Support Bracket to the rear
side of the Front Mounting Bracket, (Figure 3). Attach the Support Bracket to the back of the
pinch weld using (2) 6mm Hex Bolts, (4) 6 mm Flat Washers and (2) 6mm Nylon Lock Nuts,
(Figures 4 & 5). NOTE: Insert bolts from the outside of the pinch weld and through the
Bracket. Do not tighten hardware at this time.
4. Move to the rear mounting location and locate the threaded insert and pair of holes on the
pinch weld, (Figure 6). Repeat Steps 3 & 4 to install the Rear Brackets, (Figure 7).
5. Select the Passenger/right Sidebar. Use the illustration above to select the correct Sidebar.
Carefully position the Sidebar onto the (2) Mounting Brackets. IMPORTANT: Do not slide,
(front to back or rotate), the Sidebar on the Brackets or damage to the finish on the Sidebar
may result. Attach the Sidebar to the Mounting Brackets with (4) 8mm x 25mm Combination
Hex Bolts, (Figures 8—10). Do not tighten hardware.
6. Level and adjust the Sidebar and tighten all hardware.
7. Repeat Steps 1—7 for Driver/left Sidebar installation.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish. Mild soap may be used to clean Sidebar.
Pair of holes on pinch weld
(Fig 1) Passenger side front mounting location
Passenger/right Side Installation Pictured
Front
Page 2 of 4
(1) 8mm Hex Bolt
(1) 8mm Lock Washer
(1) 8mm Flat Washer
Front
(Fig 2) Passenger side Front Mounting Bracket
3" SIDEBAR
2018-19 WRANGLER JL 2DR
07/25/18 (RA)
Publicidad
