User Mode - Pentair 3200 NXT Manual De Uso

3200 NXT EN _P19-35

3 - USER MODE

Caution: The programming of the parameters should only be undertaken by the installer. The
modification of these parameters can cause a malfunction of the unit.
You can only enter the programming mode when the valve is in the service position. Whilst in the
programming mode, the valve continues to operate normally and registers all the information.
The program is stored in a non-volatile memory.
To enter the programming mode, press and hold the
button
3.1
Choice of language
This parameter allows you to choose which language the display will use:
- French
- English
- German
- Spanish
- Italian
3.2
Feed Water Hardness
Not visible inTimeclock mode
This parameter allows you to adjust to the water hardness at the inlet in °tH.
3.3
Calendar override
This parameter determines the maximum number of days of operation without a regeneration.
3.4
Time of regeneration
This parameter allows you to adjust the time of regeneration.
27
19/01/10 14:08 Page 27
to move to the next step. Use the buttons
S E L E C T
W A T E R
D E G R E E
C A L E N D A R
O V E R R I D E
R E G E N E R A T I O N
T I M E
and buttons for 5 seconds. Press the
and to change the values displayed.
L A N G U A G E :
F R A N C A I S
H A R D N E S S
0 0 3 0 f T H
0 3 D A Y S
0 2 : 0 0 H R
E
N
G
L
I
S
H
3200 NXT