Diagnostic Mode - Pentair 3200 NXT Manual De Uso

3200 NXT EN _P19-35
- Press and release the D button to enter the Diagnostic mode.
- Press and release the Regeneration button to go from one step to the next.
- At any time, press the D button
Depending on current settings, some displays cannot be viewed.
There is no time limit on the displays in the Diagnostic mode.
4.1
Current Flow Rate
The display is updated every second.
4.2
Peak Flow Rate
E The electronics' registers the highest flow rate since the last regeneration.
N
G
4.3
Totalizer
The electronics registers the total volume of treated water that passes through the meter.
L
I
S Reset to zero: while in this display, press and hold the buttons
display shows zero.
H
4.4
Hours between last two regenerations
This display shows the number of hours between the last two regenerations, which indicates the
length of the last service cycle.
4.5
Hours since Last regeneration
This display shows the number of hours since the last regeneration, indicating the length of the
current service cycle.
4.6
Volume remaining
This display shows volume remaining of the valve where it is installed. This parameter is
adjustable; this allows adjustments of the volume remaining after any servicing of the system.
In system #6, regeneration consecutively, the display shows volume remaining of the complete
system.
4.7
Valve position
The display shows the position of the valve in a multiple valve system.
4.8
Software version
The display shows the version of the software used by the electronics.
28
19/01/10 14:09 Page 28

4 - DIAGNOSTIC MODE

7 # 1
V O L U M E
P E A K
T O T A L I Z E R
2
L A S T
V O L
V O L
V A L V E
3 2 0 0 N X T :
V E R S I O N
to exit the Diagnostic mode.
S R V 0 8 : 2 6 H R
2 0 0 0 0 L
F L O W R A T E
O L p m
:
O
L A S T R E G E N
0 H O U R
R E G E N .
0 H O U R
R E M A I N I N G
1 0 0 0 0 0 L
R E M A I N S Y S T
0 1 0 0 0 0 0 L
P O S I T I O N :
B R 4 2 7 8 0
0 , 8
L
for 5 seconds until the
# 2
3200 NXT