Technoline WS 6445 Manual Del Usuario página 17

HOW TO SYNCHRONIZE YOUR WEATHER STATION WITH ANOTHER
OUTDOOR TRANSMITTER
1. At the back of your weather station, Press
humidity.
2. Press and hold / CHANNEL until the
outdoor transmitter at Channel 2.
3. Slide open the battery door of your second transmitter, slide the switch to the middle position marked
with 2, then insert two AAA batteries into the battery compartment by observing the correct +/- polarity.
Replace the battery cover.
4. The outdoor temperature and humidity of your second transmitter will appear on the LCD together with
icon within few seconds. If the data still does not appear, take out and reinstall batteries to your second
transmitter once.
5. To synchronize your weather station with a third outdoor sensor, repeat the same step by choosing
your weather station and select 3 on the switch on your third transmitter.
AUTO SCROLLING THE OUTDOOR TEMPERATURE AND HUMIDITY OF
DIFFERENT TRANSMITTER
Press / CHANNEL one at a time until the
humidity of different outdoor transmitter will be displayed for few seconds alternately with
To stop the auto scrolling, press
and humidity of the
LOW BATTERY INDICATION OF YOUR OUTDOOR TRANSMITTER
The icon will appear to indicate the battery level of your outdoor transmitter is getting low. You may need to replace the
batteries of your outdoor transmitter with new ones.
Extreme cold weather (e.g. below 14 °F) will also cause low battery voltage.
TROUBLESHOOTING
In case your weather station clock shows irrelevant information or digits, it maybe affected by electrostatic discharge or
interferences from other devices. Use a sharp object to press RESET at the back of your weather station. Your unit will be
reset to default settings and you need to set the time, calendar and alarm time again.
icon blinks, your weather station is searching for the signal of another
/ CHANNEL once to go back to constant display of the temperature
transmitter, the icon remains static on the display.
/ CHANNEL once. icon appears under your outdoor temperature and
icon flashes with a short beep tone. Then the outdoor temperature and
GB 8
on
flashing.
, ,