The Man Operating Mode - Kübler CODIX 533 Manual Del Usuario

SiGnal allows selecting the setpoint
–
output in volts or mA. Press both keys to switch
over from SiGn to ou.Lo and ou.HI.
output.Low allows defining the
–
lowest value.
– output.High allows defining the
highest value.
During operation, it is not possible to define a value
lower than the ou.Lo value or higher than the
ou.Hi value. The default value for ou.Lo is 0 V or 0
mA. The default value for ou.Hi is 12 V or 24 mA.
2. After setting the value of ou.Hi, press both keys;
the following message is displayed:
3. Use the right key to select YES or no.
⇑
4. If YES is selected, press both keys simulta-
neously to end the programming. The new
values are saved.
⇑ ⇑
5. The device is ready for operation.
6. If, during operation, the operator switches to the
programming mode and alters the parameters
ou.Lo or ou.Hi take into account the following
when exiting the programming mode:
If the value of parameter ou.Lo was altered, the
output of the device will automatically be set to
the value of parameter ou.Lo when it will be set
back to operation.
If the value of parameter ou.Hi was altered, the
output of the device will automatically be set to
the value of parameter ou.Lo when it will be set
back to operation.
EN - Page 6

4.2.2 The MAn Operating Mode

1. The following parameters can be programmed
for the MAn mode:
⇑ ⇑
2. Functions
Special display function,
–
see 4.2.2.1
SiGnal allows selecting the
–
setpoint output in volts or mA.
output.Low allows defining the
–
lowest output value.
output.High allows defining the
–
highest output value.
StEP allows defining the increment.
–
During operation, the setpoint output will increase
by this value when the right key is pressed. The
setpoint output will decrease by this value when
the left key is pressed.
During operation, it is not possible to define a
value lower than the ou.Lo value or higher than
the ou.Hi value.
Note
If, during operation, the operator switches to the
programming mode and alters the value of ou.Lo,
ou.Hi, di.Lo or di.Hi the parameter StEP will be
reset to zero and the output value will be reset to
ou.Lo or di.Lo.
⇑
A
see page 8
to
for mA 24.00 bei mA 24.00
to
bei mA 24.00
for mA 24.00
to
A
to
bei mA 24.00
to
bei mA 24.00
to