Installation Steps - WeatherTech 55037 Instrucciones De Instalación

Installation Steps

NOTE: Actual application may vary slightly from illustrations.
FAR SIDE EDGE
4
Begin removing remaining tape liner, beginning with the drivers side CENTER TOP. Grasping the free end, pull tape gently in 6 " (15 cm)
sections, while applying even pressure with hand to Hood Protector. Repeat process for passenger side.
CAUTION: You must apply even
pressure from center section out to
each end of part, in order for proper
adhesion to hood.
NOTE: Do not apply pressure closer than 6 " (15 cm) to tape liner as it could accidentally break.
Using the same process, remove tape liner from the driver side CENTER BOTTOM of hood protector. Repeat for passenger side.
CAUTION: You must apply even
pressure from center section out to
each end of part, in order for proper
adhesion to hood.
Page 2 of 3