Installation Steps; Care And Cleaning - WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

Center part on front edge of hood and align holes.
3
Remove remaining tape liner by pulling on exposed
ends. Apply pressure to outboard flanges to ensure
tape adhesion.
5
Close Hood.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
© 2011 by MacNeil IP LLC
NOTE: Actual application may vary slightly from illustrations.
Install (2) fasteners in the INBOARD holes.
4
Install (2) self tapping screws through the
OUTBOARD holes on hood shield.
6
Apply bump ons to surface of hood.
8
Page 2 of 2
outboard
inboard
NOTE: Do not over tighten
hood
hood shield
washer
screw