Installation Steps; Care And Cleaning - WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

Align hood shield holes with holes in hood.
3
Apply pressure to all flanges to ensure adhesion of tape.
5
Close hood and install (3) bump ons at pre-cleaned
locations on the painted hood surface.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
© 2012 by MacNeil IP LLC
NOTE: Actual application may vary slightly from illustrations.
Assemble fastener by threading screw into receptacle.
Insert (1) fastener and screw until snug. Repeat for
4
DO NOT OVER TIGHTEN
Install (3) bump ons at pre-cleaned locations on the top
6
Page 2 of 2
remaining (3) fasteners.
hood
fastener
of the grille.
tape
hood
shield