Installation Steps; Care And Cleaning - WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

NOTE: Actual application may vary slightly from illustrations.
Remove hood shield from hood. Remove the corresponding factory installed rubber seal retaining fasteners that were marked in Step 2.
NOTE: Some applications may require additional fasteners to be removed in order to fully access the holes underneath.
NOTE: Exercise extreme caution not to tear
or damage the rubber seal when separating
from hood.
Center hood shield on hood, and slide hood shield flanges UNDER Install a fastener at each flange location.
the rubber seal. Align hood shield flanges with holes in hood.
Install bump ons at pre-cleaned locations on the
Close hood. Adjust hood bump stops to raise hood as needed.
painted hood surface.

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
1 MacNeil Ct.
Bolingbrook, IL 60515
Questions? Call customer service @ 630.769.1500
www.WeatherTech.com