Installation Steps - WeatherTech Easy-On Manual De Instrucciones

Installation Steps

Attach fasteners to hoodshield by inserting screw through washer,
then through hood shield, and into well nut. Partially thread screw
into well nut.
Well nut
Hood shield
Washer
3
Align hood shield with holes in hood.
5
With the fastener assembly inserted into hole in hood,
secure hood shield to hood by tightening screw to ex-
pand well nut. Repeat for remaining fasteners.
7
NOTE: DO NOT OVER TIGHTEN
Optional Screw Attachment
9
Hood Hood shield Washer
NOTE: Actual application may vary slightly from illustrations.
Do No Overtigthen
Peel back 2" (5 cm) of tape liner on outboard flanges to expose
adhesive. Fold free ends over so they will be accessible.
4
NOTE: Observe the alignment from the side view in
order to guide the hood shield with its attached fastener
6
Remove remaining tape liner by pulling on free ends,
and apply pressure to adhere tape.
8
A power screwdriver is recommended but once the
screw penetrates the inside metal panel use a regular
phillips screwdriver the remainder of the way.
10
Page 2 of 3
into the proper hole in the hood.
Use holes in hood shield as a guide and
install (2) self tapping screws with washers
in outboard flanges.
Hood
Hood
shield
Fastener
assembly