High-Speed Stuffer Assembly Instructions - Weston BUTCHER Serie Manual Del Usuario

HIGH-SPEED STUFFER ASSEMBLY INSTRUCTIONS

w WARNING
never reach into grinder feed chute. Always use stomper. Never operate
without tray in place. Secure long hair and loose clothing before use.
Disconnect power before assembling. Always read instructions.
NOTE: The High Speed Stuffing System
is designed for use with the 10 mm Funnel
ONLY. DO NOT attempt to use the High-
Speed Plastic Auger with any other Funnels.
SERIOUS DAMAGE to the Grinder Head
and other components may occur. Follow
the "Standard Stuffer Assembly Instructions"
located in this manual, when using the 20, 30,
or 40 mm Funnels.
1. Insert the Head into the Gear Housing with
the feed chute of the Head facing straight up.
You will need to line up the slot in the Head
with the Pin inside the Gear Housing. Be sure
the Head is seated fully into the Gear Housing
(FIGURE 8).
2. Tighten the Head Locking Knob to lock the
Head into place.
3. Insert the Auger into the Head (FIGURE
9). Align the Auger Splines with
the Drive Shaft of the Grinder.
4. Slide the 10 mm stuffing funnel
onto the Auger Pin making sure
the square part of the internal
plastic auger fully seats onto the
square portion of the Auger Pin.
5. Install the Front Ring Nut, DO
NOT OVERTIGHTEN. Turn the
Front Ring Nut until it makes contact
with the Flange, then make 1/4 turn
more to tighten into place.
6. Insert the neck of the Tray into the Feed
Chute (FIGURE 10).
7. NEVER operate Grinder without the Tray
secured in place (FIGURE 10).
REFER TO "STUFFING INSTRUCTIONS"
12
Entanglement Hazard. To avoid serious or fatal injury,
Slot in Head
Feed
Chute
Head
Gear Housing
Auger Splines
Auger
Auger Pin
Front Ring
Nut
Tray
Neck
Feed
Chute
Head
FIGURE 8
Head Locking
Knob
FIGURE 9
Head
FIGURE 10