X-LITE X-661 Seguridad E Instrucciones página 15

DOUBLE ACTION
The DOUBLE ACTION button in the neutral (central) position, as illustrated in Fig. 4A,
does not affect the normal opening and closing functions of the visor. The following
additional functions can be activated by using this button:
Defogging Function
While wearing the helmet, open the visor onto the first notch and press the DOUBLE
ACTION button as shown in Fig. 4B. Now close the visor.
In this position, the mechanism keeps the visor open to a minimum to improve the
circulation of air and facilitate defogging, especially at low speeds or during short
stops.
To deactivate DOUBLE ACTION, press the button as shown in Fig. 4C bringing it
back to the neutral position.
Visor-Lock Function
While wearing the helmet, close the visor and press the DOUBLE ACTION button as
shown in Fig. 4C.
In this position, the closing mechanism on the visor is strengthened so that the like-
lihood of it accidentally opening will be reduced.
To deactivate the visor-lock mechanism, press the button as shown in Fig. 4B brin-
ging it back to the neutral position.
WARNING
- When using the helmet, it is recommended that you limit your use of the visor-
lock function, since unexpected events may require you to open your visor
immediately.
- In the event of an emergency, the DOUBLE ACTION visor lock may be disa-
bled by lifting the visor as normal, and pressing slightly harder than usual on
the visor flap.
(Available as standard or accessory/spare part).
4. Inner Visor PINLOCK
4.1. Disassemble the visor (see instructions above)
4.2. Make sure that the inner surface of the visor is clean and check that the pin
adjustment external levers are turned inwards (Fig. 5).
4.3. Place the PINLOCK
WARNING: The silicone-sealed profile of the PINLOCK
contact with the inner surface of the visor.
4.4. Insert one side of the PINLOCK
it in position (Fig. 6).
4.5. Widen the visor and fasten the other side of the PINLOCK
second pin (Fig. 7).
4.6. Release the visor.
® Assembly
® inner visor on the visor.
® inner visor on one of the visor pins and hold
15
inner visor must be in
®
® inner visor to the