Specifications - Briggs & Stratton Snapper Pro S200X32BVP61 Manual Del Usuario

NOTE: Specifications are correct at time of printing and are subject to change without notice.
Actual sustained equipment horsepower will likely be lower due to operating limitations and environmental factors.
ENGINE:
Briggs & Stratton**
Make
Briggs & Stratton
Model 543577-0110-E1
Displacement 54.62 Cu. in (895 cc)
Electrical System 12 Volt, 20 amp. Alternator, Battery: 340
CCA
Oil Capacity
2.4 US qt. (2.25 L) w/ Filter
ChASSIS:
Rear Wheels Tire Size: 24 x 12.00 -12
Inflation Pressure: 15 psi (1,03 bar)
Front Wheels
Tire Size: 13 x 6.50 - 6
Inflation Pressure: 25 psi (1,72 bar)
**Engine Power Rating Information
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of
Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance
has been obtained and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived
at 3060 RPM; horsepower values are derived at 3600 RPM. Actual gross engine power will be lower and is
affected by, among other things, ambient operating conditions and engine-to-engine variability. Given both
the wide array of products on which engines are placed and the variety of environmental issues applicable to
operating the equipment, the gas engine will not develop the rated gross power when used in a given piece
of power equipment (actual "on-site" or net power). This difference is due to a variety of factors including, but
not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application
limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due
to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for
this Series engine.
TRANSMISSIONS:
hydroGear PG-3h / hGM-12E 3131
Type
Pump and Wheel Motor
hydraulic Fluid
SAE 20W-50 motor oil
Speeds Forward: 0-10 MPH (0-16.09 km/h)
@ 3400 rpm Reverse: 0-5 MPH (0-8.05 km/h)
Continuous Torque 222 ft. lbs. (301 N.m.)
Output
Maximum Weight
750 lbs. (340 Kg)
on Axle
DIMENSIONS:
Overall Length 79" (201 cm)
Overall Width 62" (157 cm)
height 68" (173 cm)
Weight (apx..)
1175 lbs. (534 kg)
GB

Specifications

7