Unpacking; Assembly; Set Up And Operation - Shop-Vac 5HM Serie Manual De Instrucciones

UNPACKING

Remove vacuum cleaner and all accessories from the
carton. Important: Remove the tank cover by pushing
in the side lugs with thumbs and lifting up on the tabs
of the tank cover. Remove any accessories, which may
have been shipped in the tank.

ASSEMBLY

WALL BRACKET INSTALLATION
1. Select mounting location at a wall stud and/or
provide a minimum 8" wide x 12" high x ¾" thick
surface, which is strong enough to hold the weight of
the vacuum unit with a full tank of debris.
WARNING!
INADEQUATE MOUNTING COULD ALLOW THE
UNIT TO FALL, CAUSING INJURY AND/OR
DAMAGE TO THE UNIT.
FIGURE 1
FIGURE 2
ATTACH VAC
1. Grasp top handle with one hand and place other
hand under front of tank.
FIGURE 3
3. Push downward making sure slots on vacuum
(located near the bottom of the tank) attach to the tabs
located at bottom of bracket.
2. Secure wall bracket to
mounting surface with 3
screws provided or other
suitable fastener. (NOTE: The
screws provided are adequate
ONLY for mounting into wood.
Be sure to use the proper,
suitable fasteners for mounting
vacuum to a surface other than
wood.) Make sure bracket is
level. FIGURE 1.
3. The tool bag hook can be
mounted on the wall in close
proximity to the vacuum.
Secure with screws provided.
Hang tool bag onto hook
using loop in back of tool bag.
FIGURE 2.
2. Align tab on back of vacuum
(located near top of tank) to
engage with slot in center
of wall bracket as vacuum is
lowered into bracket.
FIGURE 3.
FIGURE 4
DETACH VAC
FIGURE 5
2. Grasp top handle with one hand and place other hand
under front of tank.
FIGURE 6
SET UP AND
OPERATION
DANGER
This equipment incorporates parts such as
switches, motors or the like that tend to produce
arcs or sparks that can cause an explosion.
Do not pick up flammable, combustible, or hot
materials. Do not use around explosive liquids
or vapors, as electrical devices produce arcs or
sparks which can cause a fire or explosion - do
not use at filling stations or anywhere gasoline is
stored or dispensed.
1. Refer to the filter installation and maintenance
section to make sure the correct filters are installed for
your cleaning operation.
2. Replace tank cover on the tank by aligning tabs with
the lugs. Press down firmly on the upper housing until
tank cover snaps into place.
3. Attach hose to inlet located on side of tank following
the instructions that apply to your specific unit:
4. Lower top handle on vacuum
to lay flat on top of housing.
This will secure unit in bracket.
FIGURE 4.
1. Push release lever on bracket
with thumb, while moving top
handle on vacuum to the up
position. FIGURE 5.
3. Pull upward until vacuum
detaches from bracket.
FIGURE 6.
PAGE 5