Miele professional PG 8055 Plano De Instalación página 12

Ocultar thumbs Ver también para PG 8055:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
en - Installation notes
Installation requirements
This dishwasher must be installed by an au-
thorised technician in accordance with the
installation instructions supplied.
This dishwasher must be installed in ac-
cordance with all applicable standards and
guidelines, including legal requirements and
health and safety regulations.
Electrical connection
Connection to the electrical supply should
be in accordance with valid regulations and
safety standards. The connection cable
must be protected from the risk of thermal
damage.
We recommend connecting the dishwasher
to the power supply via a suitable plug and
socket as this will make it easier to carry
out the electrical safety test during commis-
sioning and after any service work.
For hard-wired dishwashers, connection
should be made via a suitable mains switch
with all-pole isolation, which in the off posi-
tion ensures a 3 mm gap between all open
contacts.
Both the main switch and the socket must
be easily accessible after installation.
Faulty components must only be re-
placed by genuine Miele original spare
parts. Only when these parts are fitted can
the safety standards of the machine be
guaranteed. If the connection cable is faulty
it must only be replaced by a Miele ap-
proved service technician to protect the
user from danger.
Equipotential bonding and earthing
For added safety the dishwasher should be
protected with a residual current device
with a trip current of 30 mA.
Equipotential bonding should be carried
out if required. The screw connection point
for equipotential bonding is located at the
back of the dishwasher.
12
Water connection (without steam
condenser)
The dishwasher can be plumbed in to the
cold water, hot water and drainage points
without a backflow protection device. The
stopcock to the water supply must be easily
accessible.
The water supply to the dishwasher can be
connected to either cold water or hot water.
Water connection (with steam con-
denser)
The machine can be plumbed in to the cold
water, hot water, demineralised water and
drainage points without a backflow protec-
tion device. Use the enclosed Y-piece to
establish the water intake for the dish-
washer (cold water) and the steam con-
denser. Alternatively, you can install an ad-
ditional cold water line to connect the steam
condenser.
If hot water is not available, both intake
hoses (cold and hot water) must be connec-
ted to the cold water supply via a Y-piece.
The stopcock to the water supply must be
easily accessible.
Environmental requirements
Condensate can build up in the area sur-
rounding the dishwasher. Any furniture and
fittings in the room must therefore be suit-
able for purpose. If the machine is fitted un-
der a suitable worktop, the panel supplied
must be fitted above the door aperture to
protect the worktop from moisture damage.
Connecting an external dispensing
system
Up to two dispensing systems for liquid
cleaning agents and rinsing agents can be
connected to the back of the dishwasher.
Machines with integrated dispensing sys-
tems have an external connection for rinsing
agents.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pg 8099

Tabla de contenido