LED Tube Light uses LEDs as the light source, keeping the standard T8 tube's end caps,
which make it easy to install and replace a traditional fluorescent lamp.
Model LEDP-18T8FU6 and LEDP-18T8U6 is a T8 LED Tube Lamp; rated at 100~277Vac,
50/60 Hz,18W.
The package consists of two LED Tube Lamps (2 pcs) and installation instructions (1 pcs),
relamping labels (2 pcs), cautionary labels (4 pcs).
- A non-user replaceable light source which is known as a self-ballasted LED Tube Lamp.
- An electronic LED Driver was built inside the unit.
- For dry and damp location.
- Has been evaluated for use with ceiling fixtures.
- Not for use with light dimmers.
- These lamps should be installed by an electrician;
- These lamps work on line voltage and require all ballasts and starters to be removed before the bulb is to
be installed in the fixture;
- Use in -20~35 °C environmental conditions;
- Do not install in a raceway or a luminaire marked for through branch wiring.
- These devices are not intended for use with emergency exits.
- Always connect ground lead to fixture where applicable.
- These LED tube lamps are intended to retrofit maximum 2 lamps, Type IC or Non-IC recessed, or
surface-mounted fluorescent luminaire that use U tubular maximum 2-foot lamp with or without diffuser.
- Please contact your authorized dealer, distributor, or Eiko if you have any questions not addressed in
these instructions.
IMPORTANT SAFETY INSTRUCTIONS
Danger – Risk Of Shock – Disconnect Power Before Installation.
WARNING - Risk of fire or electric shock. Luminaires wiring, ballasts, or other electrical
parts may be damaged when drilling for installation of reflector kit hardware. Check for
enclosed wiring and components.
WARNING - Risk of fire or electric shock. LED Retrofit kit installation requires knowledge of
fluorescent lighting luminaire electrical systems. If not qualified, do not attempt
installation. Contact a qualified electrician.
1 General Description
2 WARNING
I