Miller Syncrowave 250 DX Manual Del Propietário página 35

3
Current (A)
Initial Amps
Preflow
Push & Release Trigger
In Less Than 3/4 Sec.
NOTE: If torch trigger is held more than 3 seconds, operation reverts to Remote Trigger (Standard) mode (see previous
page).
If arc is broken and trigger is depressed, HLP-10 will be displayed (see Section 6-1).
3 Trigger Hold
For trigger hold operation, press button to
toggle LED to Trigger Hold position.
Torch trigger operation is as shown.
Trigger Hold (2T)
2T Torch Trigger Operation
Weld Amps
NOTE: When a foot or finger remote con-
trol is connected to the welding power
source, only trigger input is functional, as
amperage is controlled by the welding
(CE Nameplate)
3
Final Slope
Final Amps
Push & Release Trigger
In Less Than 3/4 Sec.
power source.
Application: Trigger Hold (2T) can help
to reduce operator fatigue when long ex-
tended welds are made.
Postflow
OM-363 Page 29