Test Cycle - Alliance Laundry Systems HF18VCV Operación/Programación

Supply Options
Display
SUP0
SUP1
SUP2
SUP3
SUP5
SUP6
8. Press the Start key.
9. Use the Up or Down key to select the
desired spin time. Set this value to zero to
skip the spin step.
10. Press the Start key. The display will show
the identifier for next program segment or
cycle option. If the edited segment is the
final (Fill 6) segment in the cycle, the
display will show the cycle number.
Every intermediate spin is followed by a
Note:
25-second coast-down period, which occurs
during the fill step for the following segment.
11. Press the Stop key at any time to complete
the cycle programming procedure.

Test Cycle

When program mode is first entered, the
display shows temperature. To enable the
factory test cycle, press the Down key. The
display will read "tESt."
F232061
Supply
No Supply
Supply 1
Supply 2
Supply 3
Supply 1 and 2
Supply 2 and 3
Programming
To run the test cycle, proceed as follows:
1. Enter RUN mode by moving the
PROGRAM/RUN mode toggle switch
back to the down position.
2. Verify that the RUN/PROGRAM
mode toggle switch is in the RUN
position.
3. To run the test cycle, enter the required
number of coins and press the Start key.
The test cycle is as follows:
a. Once the Start key is pressed, the door
interlock engages, the drain valve
closes, the cylinder begins agitating at
wash speed, and both water inlet valves
are energized. The display alternately
flashes "bFIL" and "LO" (both hot and
cold fill valves on, filling to low level).
b. The display continues flashing "bFIL"
and "LO" (both hot and cold fill valves
on–fill to low water level), motor
agitates forward and reverse, and drain
is closed. Fill valves go off when low
water level is reached and dot above
rightmost digit lights.
c. When low water level is reached, the
display flashes "CFIL" and "
fill valve on–fill to medium water
level), basket rotates counterclockwise
and clockwise, and the drain is closed.
Fill valve goes off after medium water
level is reached and dot above third
digit from left lights.
d. When medium water level is reached,
the display flashes "HFIL" and "HI"
(hot fill valve on–fill to high water
level), the basket rotates
counterclockwise and clockwise,
and the drain is closed.
n
ed" (cold
25