Beurer easyLock BM 81 Manual De Instrucciones página 28

Adopting the correct posture
• To carry out a blood pressure measurement, make sure you are sitting upright and
comfortably. Lean back and place your arm on a surface. Do not cross your legs. Place
your feet next to each other flat on the floor.
• Always make sure that the cuff is at heart level.
• To avoid distorting the measurement, you should remain as still as possible during the
measurement and not speak.
Selecting the user
This device has 2 user memories with 120 memory spaces each in order that you can save measurements from
2 different people separately from each other.
If multiple people are using the device, make sure that the relevant user is set before each measurement.
To do so, proceed as follows:
• Press the setting button + or - on the switched-off device. The last selected user appears on the display.
• Using the +/- setting buttons, set the desired user and confirm your selection with the Start/stop button
The device then switches off automatically.
Performing the blood pressure measurement
• To start the blood pressure monitor, press the Start/stop button
elements are briefly displayed.
• The blood pressure monitor will begin the measurement automatically after approx. 3 seconds.
• The cuff inflates automatically while the actual measuring process starts. As soon as a pulse is found,
the pulse symbol
You can cancel the measurement at any time by pressing the Start/stop button
• The remaining air is released quickly once the measurement is complete.
• The systolic pressure, diastolic pressure and pulse measurements are dis-
played, and the LED risk indicator gives you a classification of your measured
values using various colours.
• appears if the measurement could not be performed properly. In this case,
please read the section "What if there are problems?".
• If the Bluetooth
"beurer HealthManager" app starts automatically after the measurement.
• The Bluetooth
®
approx. 30 seconds.
• The Bluetooth
®
is transferred to the apps. Once the data transfer is successfully complete, the device switches off
automatically.
is displayed.
function has been activated, the data transfer to the "beurer HealthManager Pro" or
®
symbol flashes on the display. The device now attempts to connect to the app for
symbol stops flashing as soon as the connection is established. All measurement data
. All display
28
.
.