EGO PTX5100 Manual Del Usuario página 23

7. Remove the blade assembly from the tool and ensure that the eccentric block
assembly position remains unchanged.
8. Align the inward bulge on the new blade assembly with the hole inside the link
lever to install the new blade assembly into place.
9. Insert the two bushings into the two rounded rectangle separately.
10. Mount the support plate 1 and then mount the support plate 2.
11. Keep the inside holes in the blade, the bushings, and the holes in the support
plates in line with the screw holes in the gear case. Install the 2 long screws into
the aligned holes and tighten them securely (Fig.12).
12
Long Screw
Support Plate 2
Support Plate 1
Bushing
Inward Plug
Outward Plug
HEDGE TRIMMER ATTACHMENT — PTX5100/PTX5100-FC
Rounded Rectangle Slots
Screw Holes in the Gear Case
Hole inside the Link Lever
23