EGO PTX5100 Manual Del Usuario página 24

12. Slightly move the upper blade back and forth to check whether the blade can
move freely. If not, reassemble the blades until the upper blade can move freely.
13. Install the link lever.
14. Align the hole of support plate 3 with the bulge on the eccentric block to install
the support plate into place, ensuring that the plate is exactly located in the
center, parallel to both edges.
15. Mount the bottom cover onto the gear case and secure it with 6 short screws
(Fig. 13).
13
Short Screw
Bottom Cover
Support Plate 1
Link Lever
16. Start the hedge trimmer to check whether the hedge trimmer can work normally.
If it does not, reassemble following the above steps.
24
HEDGE TRIMMER ATTACHMENT — PTX5100/PTX5100-FC
Bulge