Publicidad
Step 20
Step
NOTE: Start all of the SCREWS before completely tightening any of them.
å
Fasten the SMALL WIRE BACK (K) to the SMALL LEFT END (D). Tighten two
å
BLACK 1-3/8" HEX HEAD SCREWS (16) using the L-Wrench (14).
Fasten the LEFT BOTTOM (W) to the SMALL LEFT END (D). Tighten three
å
BLACK 1/2" HEX HEAD SCREWS (20) using the L-Wrench (14).
Fasten the SHORT LEFT TUBES (X) to the SMALL LEFT END (D). Tighten
å
two BLACK 1-3/8" HEX HEAD SCREWS (16) using the L-Wrench (14).
14
BLACK 1-3/8" HEX HEAD SCREW
(4 used in this step)
Page 24
X
D
J
K
16
www.sauder.com
X
W
BLACK 1/2" HEX HEAD SCREW
(3 used in this step)
20
420650
Publicidad
